Help
#1
Help
Hi i just bought a used 1996 mustang and i was wondering what i should do with it to make it a little bit faster or what i should do with the engine because it has 148000 miles on it i would appreciate your help thank you.
#4
Honestly, with 148,xxx I'd recommend saving your money. There's really no telling how the car was treated over the last 10+ years.
Save your money until you can do a motor swap to a beefed up 3.8 or 4.2 if you want to stick with the six. http://rpm-mustangs.com/home.php
If you prefer to just mod.
Upgrade to an 8.8" rear end with some 4.10 gears.
Tune the car, reset the speedo for the gears.
CAI's really don't give the 3.8's any significant gain (although they do look nice.)
Save your money until you can do a motor swap to a beefed up 3.8 or 4.2 if you want to stick with the six. http://rpm-mustangs.com/home.php
If you prefer to just mod.
Upgrade to an 8.8" rear end with some 4.10 gears.
Tune the car, reset the speedo for the gears.
CAI's really don't give the 3.8's any significant gain (although they do look nice.)
#5
would sumthing like this work and if so how would i get it put in and where etc... http://rpm-mustangs.com/product.php?...cat=263&page=1
#10
This is a good site, best engine prices i have seen...
http://www.rhinoengines.com/fordcrateengineslist.htm
http://www.rhinoengines.com/fordcrateengineslist.htm
#13
Thats for a stock 99-04 3.8L v6 screw that. The stock v6 motors are tuff they are said to be good till the 450rwhp rang. If i was you get one locally from a junkyard or salvage place and do the split port motor swap (99-04 motors are called split port).
There is minor wiring that has to be changed and some connectors but not bad. Can be done with some freinds over a weekend or 2.
There is minor wiring that has to be changed and some connectors but not bad. Can be done with some freinds over a weekend or 2.
#14
Thats for a stock 99-04 3.8L v6 screw that. The stock v6 motors are tuff they are said to be good till the 450rwhp rang. If i was you get one locally from a junkyard or salvage place and do the split port motor swap (99-04 motors are called split port).
There is minor wiring that has to be changed and some connectors but not bad. Can be done with some freinds over a weekend or 2.
There is minor wiring that has to be changed and some connectors but not bad. Can be done with some freinds over a weekend or 2.
#15
motor
go to www.mustangsunlimited.com you can get a v6 motor for about 1900 to 2 grand which is not bad for a brand new motor. check it out.
Thread
Thread Starter
Forum
Replies
Last Post
trickedoutstangg
The Lounge
13
06-30-2005 09:51 PM