I bought a hi/lo H.I.D kit from americanmuscle for my mustang gt 1996,
i thought it was a plug and play but i realize it's not the case,YES i have read the instruction.Where do you guys take your pos(+)?
if i take the pos directly from the batterie my light will stay on all the time.I have to pass by the switch.They ask me to install a relay...ok,but how???

How do you guy installed your kit???

 

scan your wiring diagram to me. single hid ballast require only one bat. pos.
and one ground. you need to check to see if you stock headlights are turned
on by a pos. signal or neg. signal, this will be helpful in wiring the relay
to run your ballast.if your kit didnt come with relays that you need (2)
they can be purchased at any parts store. with a dual hid sys. there
will be two signals (low,high) still easy to wire. cmkjs31@yahoo.com