so i destroyed my UCA bushing trying to install some steeda adjustables. i have to wait till tomorrow to finish the job.

any of you have problems with the old bushings coming out? mine seem like they were glued in and i didnt clean out the shaft well enough when in put the steeda bushing in so i F'd that peice all up.

 

never use poly upper bushings = my advice.

 

these are the ones that are connected to the axle not the chassis. the chassis end is poly the axle end is rubber and i jacked the rubber peices up because i tried to rush the job.

after tomorrow my car will have one new rubber bushing supplied by steeda and the stock one with 90k miles on it.

 

its 1020 am and im late starting on round 2 for this fawkin car. hopefully i will be done before 5 pm. i have other small projects to do.