Let's have some fun shall we...
#1
Let's have some fun shall we...
Post up just your power adder and it's supporting mods. I'm curious how many PA stangs there are on here.
My sixer:
-NX mainline kit (75 shot)
-Dual purge
-FPSS
-WOT switch
-NHRA Fitting and Blow Down Tube
-Bottle pressure gauge
-Converted fuel feed lines (Mainline kit has rubber fuel lines) from rubber to braided SS
-NGK spark plugs
- Dyno tune by Racers Edge Tuning in Downey, CA. SCT 4 bank chip with an N/A and N2O tune
My sixer:
-NX mainline kit (75 shot)
-Dual purge
-FPSS
-WOT switch
-NHRA Fitting and Blow Down Tube
-Bottle pressure gauge
-Converted fuel feed lines (Mainline kit has rubber fuel lines) from rubber to braided SS
-NGK spark plugs
- Dyno tune by Racers Edge Tuning in Downey, CA. SCT 4 bank chip with an N/A and N2O tune
#3
KB Twinscrew 1.7L Supercharger W/ 9 PSI of boost
Bar and Plate Intercooler
HD Heat Exchanger
Intercooler Pump
Water Fill Reservoir
36lb Injectors
Boost-A-Pump
160° Calibrated Thermostat
70mm Throttle Body & "Big Tube" Kit
Dyno tuned by Ed Clark at Steen Racing...sct x-cal 2 with 3 tunes- safe, street, and shootout
Bar and Plate Intercooler
HD Heat Exchanger
Intercooler Pump
Water Fill Reservoir
36lb Injectors
Boost-A-Pump
160° Calibrated Thermostat
70mm Throttle Body & "Big Tube" Kit
Dyno tuned by Ed Clark at Steen Racing...sct x-cal 2 with 3 tunes- safe, street, and shootout
#10
stroker 302 livernois forged roataing assembly- (5.0l)
Livernois ported 3 valve heads- flow #'s are 309 in. 218 ex.
Comp cams
3v intake with steeda charge motion plates
03 cobra TB and Lightning MAF, custom CAI
Mac longtubes, catted H pipe, Borla Catback
Nitrous......IDK
Livernois ported 3 valve heads- flow #'s are 309 in. 218 ex.
Comp cams
3v intake with steeda charge motion plates
03 cobra TB and Lightning MAF, custom CAI
Mac longtubes, catted H pipe, Borla Catback
Nitrous......IDK
#11
Mods:Procharger intercooled supercharger,8lbs (Installed and tuned professionaly by Johnny lightning performance).42lbs Injectors, 255lbs fuel pump, 90mm mas air, Diablo maf adapter, Diablo flip chip tuned by Johnny lightning, bbk off road x-pipe, 40 series flowmaster mufflers welded in slp catback, 04 cobra frpp 6spd conversion, spec stage 2 clutch, spec steel flywheel, light weight custom shortend aluminum drive shaft, t-56 steeda short throw shifter.
#14
Power adder:
Compucar EFI 4.6 kit 125 & 150hp pills used.
Supporting mods:
SVT focus pump
Spec Stage 2 clutch
FPSS
MSD Digital Window switch
Nitrous Pressure guage
Fuel pressure guage
A/f guage (soon to be wideband)
Compucar EFI 4.6 kit 125 & 150hp pills used.
Supporting mods:
SVT focus pump
Spec Stage 2 clutch
FPSS
MSD Digital Window switch
Nitrous Pressure guage
Fuel pressure guage
A/f guage (soon to be wideband)
Thread
Thread Starter
Forum
Replies
Last Post