Pics for those that don't watch the 5.4 swap thread.
#1
Pics for those that don't watch the 5.4 swap thread.
How about some eye candy for the kiddies. 5.4 swappers only, please post pics of your parts. Everyone else save them replies... I'll delete them if they're not parts on a 5.4 swap.
Motor pics are ok but limit it to 3 max of any specific complete motor, installed or not. And make sure they're nice pics.
Motor pics are ok but limit it to 3 max of any specific complete motor, installed or not. And make sure they're nice pics.
#2
Back when plates were it, I had them all. This pic was taken before Pro-Prod had come out with their final design. Saleen S330 and I did the initial testing on them. The plates were fine, even a little better fitting than the reichards in the pic but the Pro-Prod intake was crap.
Here's the intake gear Pro-Prod sent me:
Pro-Prod rails are total crap BTW..., they leak because of a poorly designed retainer bracket setup. 1 little bit of effort would have fixed it but nooooo.
Here they're installed on my HPS 4.6 intake.
CPR Fuel rails before paint
CPR fuel rails after paint
My first HPS 5.4 intake:
Headers
Motor parts
Click on the slide show!
Here's the intake gear Pro-Prod sent me:
Pro-Prod rails are total crap BTW..., they leak because of a poorly designed retainer bracket setup. 1 little bit of effort would have fixed it but nooooo.
Here they're installed on my HPS 4.6 intake.
CPR Fuel rails before paint
CPR fuel rails after paint
My first HPS 5.4 intake:
Headers
Motor parts
Click on the slide show!
Last edited by r3dn3ck; 06-10-2010 at 07:47 AM.
Thread
Thread Starter
Forum
Replies
Last Post
WaterDR
SMACK Talk!
18
09-06-2005 12:58 PM
PistolWhip
Pictures
15
04-11-2005 08:40 PM