Modular 4.6L Tech For all your 1996-2005+ 2V, 3V, and 4V modular motor needs.

Whats Next

Old Dec 9, 2007 | 10:28 AM
  #1  
Chasinsparks's Avatar
Thread Starter
|
Member
Joined: Feb 2006
Posts: 80
Default Whats Next

Ok Last week I wrote about Idle problems, and try various fixes heres what has been done

First the car is a 2004 Gt, Has streen racing stage 2 heads, comp 270 cams, SCT Custom tune, Longtube headers, 70 MM throttle body & plenum, 4:10 gears.

It started Idleing ruff and then got to the point where it would rev about 1500 rpms then drop way low then shoot back up, then to where it would Idle for 30 seconds and shut off.

I have cleaned the MAF, replaced the IAC, Replaced the PCV

The code is P21107< o2 sensor I have put two different one in, I just finished replacing the o2 sensor, had the battery disconnect, use a diablo tuner to clear the code, It seem to ilde ok took it for a ride seemed ok parked it, went back out about 10 mins later start the car and the check engine light is back on reading o2 sensor
 
Old Dec 9, 2007 | 11:56 AM
  #2  
03gtmustang's Avatar
Super Moderator
Joined: Jan 2005
Posts: 3,440
From: Northern Va
Default

Same code?
 
Old Dec 9, 2007 | 02:39 PM
  #3  
Chasinsparks's Avatar
Thread Starter
|
Member
Joined: Feb 2006
Posts: 80
Default Yeah

Same code
 
Old Dec 9, 2007 | 10:07 PM
  #4  
03gtmustang's Avatar
Super Moderator
Joined: Jan 2005
Posts: 3,440
From: Northern Va
Default

I cant find P21107.
 
Old Dec 10, 2007 | 01:20 AM
  #5  
Chasinsparks's Avatar
Thread Starter
|
Member
Joined: Feb 2006
Posts: 80
Default oops

I fat finger it P2197
 
Old Dec 10, 2007 | 04:40 AM
  #6  
Bwhipple's Avatar
In hibernation
Joined: Jun 2006
Posts: 318
From: Central PA
Default

P2197
Lack of HO2S-21 Switch, Sensor Indicates Lean
Detailed Description
A heated oxygen sensor (HO2S) indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time.
Possible causes :-
Electrical:
# Short to VPWR in the harness or HO2S.
# Water in the harness connector.
# Open/shorted HO2S circuit.
# Corrosion or poor mating terminals and wiring.
# Damaged HO2S.
# Damaged powertrain control module (PCM).
Fuel System:
# Excessive fuel pressure.
# Leaking/contaminated fuel injectors.
# Leaking fuel pressure regulator.
# Low fuel pressure or running out of fuel.
# Vapor recovery system.
Induction System:
# Air leaks after the mass air flow (MAF) sensor.
# Vacuum Leaks.
# PCV system.
# Improperly seated engine oil dipstick.
EGR System:
# Leaking gasket.
# Stuck EGR valve.
# Leaking diaphragm or EVR.
Base Engine:
# Oil overfill.
# Cam Timing.
# Cylinder compression.
# Exhaust leaks before or near the HO2S(s).
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
GotMyStang
V6 Tech Forums
14
Feb 1, 2007 03:54 PM
G PURE 260 STANG T
The Lounge
6
Mar 28, 2006 10:03 PM
Icefreezen
The Lounge
11
Mar 25, 2006 10:58 AM
00PerfRedGT
Modular 4.6L Tech
9
Mar 25, 2006 09:21 AM
erk2581
Modular 4.6L Tech
5
Jan 29, 2006 12:55 PM


Thread Tools
Search this Thread

All times are GMT -7. The time now is 07:15 PM.