I am tying up the loose end on my project and there are a few thing I was hoping I could get some help with.


1. Where does the MAP sensor hook up to ?? I know where the electrical plugs in but there is a place for two vaccum lines and I dont know what ones or where they run to.

2. Starter wiring. I do not remember what wires went where one my starter. I think there are only two but I dont want cross them.

3. Plenum vaccum lines. I have a new motor and Im trying to remember where all the vaccum lines run.

If anyone could help me out with pics of this stuff it would help me out soo much. I promise to remember you when Im rich !!! Thanks in advance !!

 

For the starter, the thicker wire goes on the stud w/ the bigger nut (I think 10mm vs. 8mm).