What will this give me?
#1
What will this give me?
How much horsepower will this setup make and what kind of times can expect to run with good driving (02 GT 5-speed)
1. VT stage 1 Cams or some comp cams or whatever
2. Steen Racing or AFR heads
3. 3.73 gears
4. steeda tri-ax
5. bassani x-pipe
6. SLP catback
7. K&N Filter
8. Nitto 555R's
9. Maybe C&L Plenum and Accufab 75mm tB
10. Maybe steeda UDP's
LMK what u think any changes etc. LMK what i will make with the 1-8 and also the 1-10. thanks
1. VT stage 1 Cams or some comp cams or whatever
2. Steen Racing or AFR heads
3. 3.73 gears
4. steeda tri-ax
5. bassani x-pipe
6. SLP catback
7. K&N Filter
8. Nitto 555R's
9. Maybe C&L Plenum and Accufab 75mm tB
10. Maybe steeda UDP's
LMK what u think any changes etc. LMK what i will make with the 1-8 and also the 1-10. thanks
#2
Id go with vt stage 2 cams and steen stage 2 port and polish. Youll also need some kind of chip/tune, go with an SCT chip. When you have all this power youll need some good tires to get it to the ground, Id go with slicks or et streets.
#5
With the following mods, I was only able to get a 13.40 out my combo and thats was driving the hell ouuta the car. I think 60ft was a 1.79.
1999 GT
4.10
Magnaflow Catback
Bassani X-pipe
Steeda Trix-Ax
Spec Stage one clutch
Eibach sport springs
Ported Upper plenum
Ported Stock throttle body
JDM Superchip
Chrome Cobra R's
Nitto 245/275 Drag Radial
Zex Wet Kit 75 H.P. 100H.P.
13.40@103 N/A
Ported heads, cams and pulleys should put you about 45 horsepower ahead of me, so that be good for about a half second. Most of the N/A cars Ive seen in the 12's need long tubes and atleast 4.10 gears. Also most have signifigant weigth reduction like a tubular K member, rear seat delete and slicks and skinneys.
1999 GT
4.10
Magnaflow Catback
Bassani X-pipe
Steeda Trix-Ax
Spec Stage one clutch
Eibach sport springs
Ported Upper plenum
Ported Stock throttle body
JDM Superchip
Chrome Cobra R's
Nitto 245/275 Drag Radial
Zex Wet Kit 75 H.P. 100H.P.
13.40@103 N/A
Ported heads, cams and pulleys should put you about 45 horsepower ahead of me, so that be good for about a half second. Most of the N/A cars Ive seen in the 12's need long tubes and atleast 4.10 gears. Also most have signifigant weigth reduction like a tubular K member, rear seat delete and slicks and skinneys.
Thread
Thread Starter
Forum
Replies
Last Post
rawhead
5.0L Tech
6
02-04-2005 04:51 PM