Removing Isolators
#1
Removing all Isolators
Ever since I installed my Pro-Kit there has been a little squeak from the rear...I have a buddy that offered me his new isolators cause he's not using any and it rides and sounds fine...plus it will drop it another 1/4 to 1/2 inch. I think I'm going to take my isolators out this weekend but I wanted to see if anyone else here is not using them.
#2
Sort of a good idea
The guys at Steeda told me I could run without the isolators that thread over the top end of the coil springs, but running without the flat isolators that are over them would probably create a squeak.
Seems logical to me.
tripleblack
Seems logical to me.
tripleblack
#4
Looks like a plan
Thats right.
You'll still drop the car a quarter inch, or a bit less.
You might consider swapping out the used isolators for polyurethane versions, particularly if the oe versions are toast.
tripleblack
You'll still drop the car a quarter inch, or a bit less.
You might consider swapping out the used isolators for polyurethane versions, particularly if the oe versions are toast.
tripleblack
Originally Posted by MineralGT
So I need to use the flat isolator that goes on top but not the one that fits like a sleeve around the 1st coil?
#5
Originally Posted by tripleblack
Thats right.
You'll still drop the car a quarter inch, or a bit less.
You might consider swapping out the used isolators for polyurethane versions, particularly if the oe versions are toast.
tripleblack
You'll still drop the car a quarter inch, or a bit less.
You might consider swapping out the used isolators for polyurethane versions, particularly if the oe versions are toast.
tripleblack
Thread
Thread Starter
Forum
Replies
Last Post