hey guys my driver side door is sagging kind of low on my stang and water is now leaking in b/c the window does not tuck all the way under the verts top how do i go about adjusting the door to be raised up about half an inch?

 

Theres sum bolts that hold that door together... Get a floor jack ready with some padding for the door to rest on top of on the jack..loosen a little... jack it up the door little by little till you figure you cleared the half inch..go just a hair above....tighten hard...lower jack....and test...
I am about to do the same when it warms up... im only down a hair..
Make sure your window is up also..

Hope this helps GL

 

isnt this one of the reasons Sub Frame Connectors are a plus? To help alleviate this from happening

 

yeah, dam doors are so heavy. I would change that pin out also, that goes thru the bracket, if you look close it will be real worn out.