How much horsepower will this setup make and what kind of times can expect to run with good driving (02 GT 5-speed)
1. VT stage 1 Cams or some comp cams or whatever
2. Steen Racing or AFR heads
3. 3.73 gears
4. steeda tri-ax
5. bassani x-pipe
6. SLP catback
7. K&N Filter
8. Nitto 555R's
9. Maybe C&L Plenum and Accufab 75mm tB
10. Maybe steeda UDP's

LMK what u think any changes etc. LMK what i will make with the 1-8 and also the 1-10. thanks

 

Id go with vt stage 2 cams and steen stage 2 port and polish. Youll also need some kind of chip/tune, go with an SCT chip. When you have all this power youll need some good tires to get it to the ground, Id go with slicks or et streets.

 

The AFR heads have me a little confused... Im assuming you dont mean the push rod head ?? LOL Thats a pretty good set up, Id guess you be close to 300hp at the flywheel. With some traction should be a very low 13 or high 12.

 

I think i would be in mid to low 12's because i've seen people run high 12's with only a fewbolt-ons and some good driving.

 

With the following mods, I was only able to get a 13.40 out my combo and thats was driving the hell ouuta the car. I think 60ft was a 1.79.

1999 GT
4.10
Magnaflow Catback
Bassani X-pipe
Steeda Trix-Ax
Spec Stage one clutch
Eibach sport springs
Ported Upper plenum
Ported Stock throttle body
JDM Superchip
Chrome Cobra R's
Nitto 245/275 Drag Radial
Zex Wet Kit 75 H.P. 100H.P.
13.40@103 N/A

Ported heads, cams and pulleys should put you about 45 horsepower ahead of me, so that be good for about a half second. Most of the N/A cars Ive seen in the 12's need long tubes and atleast 4.10 gears. Also most have signifigant weigth reduction like a tubular K member, rear seat delete and slicks and skinneys.