Check Out My Throttle Body!
#4
Thanks alot guys. We were just experimenting with a new chrome powder and clear powder. The powder coating shouldnt affect the heat any at all. The pics really dont do it justice actually,, it looks more like a polished aluminum in person,, it is very reflective.
#12
Originally Posted by GT4POINT6
what u mean accident?? Was it that hard to put back together??
#14
Originally Posted by matrixpuba
i was putting on the udp and i couldnt get the pulley off. i even took off the alt. and still couldnt get the pulley off. then came out the torch and i heated the nut up, put on the impact and still couldnt get it off. so i lost me temper and showed my ignorance and i had to buy a new alt. i had to pay 200 bucks for a new one. i broke the case with a breaker bar. man school was expensive:surrender
#18
thanks only bout an hour. I cleaned it in a bench grinder with a wire brush,, then hand polished it with mothers aluminum polish about 10 times. I could probally make it look alot better with like a dremel tool with a buffin bit on it. but all i had was rags and my hands. But if you look at it in the pic up top,,, it looks 100times better.
#20
Originally Posted by MT's#1Customer!
Does your buddy do brake calipers?
#23
Originally Posted by GT4POINT6
how do i make pics smaller?
grab the "image Resizer" from Microsoft. It's very simple.
http://www.microsoft.com/windowsxp/d...powertoys.mspx
Thread
Thread Starter
Forum
Replies
Last Post
RCTrucker7
General Tech Forum
5
07-16-2009 04:26 PM
RCTrucker7
Modular 4.6L Tech
7
05-27-2006 08:34 AM
dsg_gt2004
The Reference Section
12
03-22-2005 07:48 PM