Ok, motor and tranny are in the car. Had to buy another 3/8" spacer and then cut it down to a 1/4" (double stack. put it above my one inch spacer) so that the upper intake could be put on and clear the valve covers. Upper is on just for mock-up at this point. Won't be long now guys.

 

 

Is your cowl gunna be big enough? lol.

 

wow looks sick, and talk about tight fit on that upper.

 

I hope,,,cross your fingers for me please.

Little did I know that Holley reccomends the Trick Flow valve covers for their kit,,seeing as how it is one of only a few valve covers that will fit under their intake. You shoulda seen me pitchin a fit when it hit my new valve covers,,,even with a 1" spacer.

 

you have a prime example of a badass fox body. Clean in and out, and done right!

Yours is my favorite fox, next to my buddies brothers whos got a sonic blue one with a 427 in it.

 

very good and clean work sir! i dont look forward to the day when my car comes that far apart

 

wow that looks amazing

 

Matt, thank you so much for the comment, really means alot!!!

 

One of my dreams is to build a fox body. 91-92 Notch! Your car is very beutiful by the way good job.

 

look great, are you gonna fill the holes in the firewall and wheel wells?

 

Nah, not gonna fill the holes in. I just wanted a nice clean engine bay so when I open the hood it looks good. Now if I was building a car that I planned on shoing alot,,,,different story. Drivers side wheelwell liner still has to go back in. Gonna get some more done today I hope.

 

would having 2 spacers on the intake, affect your performance or will it blow intake gasket. Just asking causing I have the same intake w/the same valve covers, and I was going to do the same thing instead of buying custom made valve covers.

 

Since I bought the kit used and no directions I didn't get the paper that says to use the Trick Flow valve covers (will clear roller rockers.) If I woulda known that I woulda had no problem w/just the 1" spacer. I hope it doesn't effect performance. Once it's up and running I'll get it dyno'd and see what it looks like. If it's not what I expect I'll definitely get the appropriate valve covers and go back to the 1" spacer by itself.