Hi guys!

Just a simple question, I'm going to install my nitrous wet kit, is it better to route the long nitrous hose inside or outside the car ?

Since the kit is used, do I need to put something on the fittings ? Teflon, glue, lock tite, special product ?

Thanks
Kevin

 

it doesnt matter. I ran mine outside cause it was easyer. and you need ot use teflon paste not tape. thsi will keep it form leaking out.

 

if you mount the bottle in the trunk on the pass side, there is a grommet pretty much where the nipple on the bottle will be facing, it leads into the framerail, i just routed my line down through it and out the side just before it is welded to the floordoard where my subs are welded in. Then just secured it to my fuel lines all the way into the engine compartment.