ABS LIGHT ON
#6
make sure your sensor is plugged in, connected to the axle and sitting close enough to the tone ring to work (about 5-10 sheets of paper away). Also make sure the sensor and tone ring are at least reasonably clean.
Don't forget to check the other sensors too.
Don't forget to check the other sensors too.
#7
How did you get the ABS sensor out of the bracket to allow the axle C clip removal? Were there channelocks or vice grips involved? If it came out fairly easy, then just make sure it's clean of all the little shavings. If it was a PITA like usual, it may be damaged from the removal process and need replaced.
Or maybe you just forgot to plug it back in.. it happens
Or maybe you just forgot to plug it back in.. it happens
Thread
Thread Starter
Forum
Replies
Last Post