Fog lights
#1
01-19-2007 | 06:12 AM
Thread Starter
|
Mustang Superman
Joined: May 2005
Posts: 3,907
From: Your mom's bed
Fog lights
My fog lights are both dead now. One went out then the other did. I think one of the housing has water in it. Is there a easy way to change the bulbs out or what I dont see a way to take them out?
#2
01-19-2007 | 07:22 AM
Senior Member
Joined: Dec 2004
Posts: 10,237
stick your arm in there and twist either left or right about 30 degrees. youll then have to remove them from the harness. shouldnt take you more than 30 seconds on each side. its exactly the same as your headlights.
my stock ones leaked so i switched to the ultra clear ones and those leaked too. i eventually removed them and ran a bead of silicone along them. id pull your bulb out, and let them air dry out for a few days as well.
my stock ones leaked so i switched to the ultra clear ones and those leaked too. i eventually removed them and ran a bead of silicone along them. id pull your bulb out, and let them air dry out for a few days as well.
#3
01-19-2007 | 08:03 AM
Thread Starter
|
Mustang Superman
Joined: May 2005
Posts: 3,907
From: Your mom's bed
stick your arm in there and twist either left or right about 30 degrees. youll then have to remove them from the harness. shouldnt take you more than 30 seconds on each side. its exactly the same as your headlights.
my stock ones leaked so i switched to the ultra clear ones and those leaked too. i eventually removed them and ran a bead of silicone along them. id pull your bulb out, and let them air dry out for a few days as well.
my stock ones leaked so i switched to the ultra clear ones and those leaked too. i eventually removed them and ran a bead of silicone along them. id pull your bulb out, and let them air dry out for a few days as well.
#4
01-19-2007 | 09:09 AM
Administrator
Joined: Sep 2004
Posts: 11,974
From: Orlando,Florida
my stock driverside got a hole in it from debree on the road. I replaced them with the clear ones form AM and sealed them up with silicone before i tossed them on. Been good so far and its been over a year no water etc...
#5
01-19-2007 | 07:49 PM
Thread Starter
|
Mustang Superman
Joined: May 2005
Posts: 3,907
From: Your mom's bed
stick your arm in there and twist either left or right about 30 degrees. youll then have to remove them from the harness. shouldnt take you more than 30 seconds on each side. its exactly the same as your headlights.
my stock ones leaked so i switched to the ultra clear ones and those leaked too. i eventually removed them and ran a bead of silicone along them. id pull your bulb out, and let them air dry out for a few days as well.
my stock ones leaked so i switched to the ultra clear ones and those leaked too. i eventually removed them and ran a bead of silicone along them. id pull your bulb out, and let them air dry out for a few days as well.
Thread
Thread Starter
Forum
Replies
Last Post
