Question about connecting steering shaft and column
#1
11-11-2006 | 11:36 AM
Thread Starter
|
Junior Member
Joined: Nov 2006
Posts: 24
Question about connecting steering shaft and column
I just replaced the heater core.(details on that later)
Go the dash back in,and Im securing that.
How do I make sure that the steering shaft is dialed in correctly with the wheel ? When the two are not connected ,the wheel will turn forever while turning right .If I turn it to the left ,it will come to a stop after a few turns.
What position does the wheel need to be in ,when I put the shaft into the connection for the steering column? Also, what about the groove on the top of the shaft ? How should that be located ?
its a 97GT
Go the dash back in,and Im securing that.
How do I make sure that the steering shaft is dialed in correctly with the wheel ? When the two are not connected ,the wheel will turn forever while turning right .If I turn it to the left ,it will come to a stop after a few turns.
What position does the wheel need to be in ,when I put the shaft into the connection for the steering column? Also, what about the groove on the top of the shaft ? How should that be located ?
its a 97GT
Thread
Thread Starter
Forum
Replies
Last Post
