I am trying to plan out my day tomorrow for installing my prochamber pipe and I have the wired in type MIL eliminators. In the directions it says how to wire them in but then says to re-install the O2 sensor in the pipe. I pick up my pipe in the morning so I dont know if it has the bong welded in already for the sensors.


My question to you guys is. Does the pipe have a connection for the sensor and if it doesnt where to the sensors go? Do they get connected back in at all? And if so where? confused here a little. and did a small search but didnt find anything on this topic yet

this is what I have from: http://mach1performance.org/traction.htm#mil

 

The pro pipes I've seen have the o2 bong in already. The reason you have to put the sensor back in is to PLUG the hole. If it doesn't have bongs, just wire the MILs and hang out of the way. I'm 99.98767% sure it has bongs.

 

Duuude, who's got the bong?

I think ya'll mean BUNG. But yeah, they should already be there. Not to worry.

 

I thought it was bung!!!LOL.

 

bung, bong. I know what was on my mind.....puff puff pass