Stainless Steel Bumper Inserts
#2
10-27-2005 | 02:04 PM
www.socalstangs.com
Joined: Feb 2005
Posts: 1,116
From: San Diego, Cali
Originally Posted by Fryguy22
Do these inserts come with adhesive on them? If not, what should i get to apply them. Also, how thick is the stainless steel and what gauge steel is it.
#3
10-27-2005 | 02:42 PM
Sigma Beta Rho Soldier
Joined: Mar 2005
Posts: 2,682
From: Philadelphia, PA
My suggestion is to get a stronger adhesive. I have read on many forums that these inserts (made by UPR) tend to come unstuck after a while. Get some 3M Bonding tape and it should hold it a LOT better.
#4
10-27-2005 | 03:48 PM
Super Moderator
Joined: May 2005
Posts: 9,684
From: Carthage, Missouri
Bought mine from here I think and have had no problems.Once you put them on you better hope they are straight cause that **** sticks tight.Mine had the glue(tape)already on them just pulled the backing off and installed them.
#6
10-27-2005 | 09:53 PM
Guest
Posts: n/a
Do yourself a big favor, wwhen you put em on and press them in, do NOT apply more pressure towards the middle of the letters or they will kinda warp and stick out on the sides, then you gotta get a screwdriver and stick it in the middle while pushing the sides to get em looking right.
wwhen you put them on, apply pressure on the outside only, never the center.
wwhen you put them on, apply pressure on the outside only, never the center.
Thread
Thread Starter
Forum
Replies
Last Post
caveman5305
AmericanMuscle
1
11-06-2005 09:02 PM
