Headers for 1998 3.8L stang
#1
Headers for 1998 3.8L stang
i have a 1998 mustang 3.8L modded wit flowmatser 40 series, BBK throttle body, BBK air intake, and under drive pulley. i want more horses form my car and looking to get new headers. im tired of stock. i was wonder if anybody knew of the best headers for a 98 3.8L?
#2
dude, i wouldn't go with headers. on the 3.8L the short tube headers are not very restrictive at all. if you seriously want more HP, then do a head, cam, and intake upgrade. you already have split port heads, so you might not even have to upgrade those, just port them out a little bit.
#6
true... depending on the milage of his car and how often he decides to run with the nitrous on.
#7
Then again theres guys with 120 thousand miles running nitrous every weekend at the track, but they've taken decent care of their cars.
#8
my ride has 90K miles on it. but it hasn't been driven hard at all, and has always gotten regular maintenance.
therefore i'm going to be doing a 4.3L stroker kit with forged internals for the engine, a h/c/i swap, LT headers, a catted h-pipe, and a 75 shot of nitrous for the car.
why? because honestly now the car has become a weekend toy because i work in manhatten and don't drive in at all, and don't care about milage anymore.
#10
even a 100shot on the v6 can be done rather safely on a stock motor. But a 75 shot can be done all day long on a stock motor. You guess don't realize how strong that motor is stock. There are guys pushing alot of HP threw stock motors in the 3.8L they are tuff bitches. And 98 doesnt have split port heads its still single port.
#11
^^^^i was planning on getting that already but my wife says its too dangerous, but i tell her if its like over 150 shot then thats dangerous, and so wat nitrous system do u reccomend on getting though?
Thread
Thread Starter
Forum
Replies
Last Post
Steve@CJPP
Sponsors
1
01-31-2016 03:22 PM