replacing turn signal bulbs
#1
replacing turn signal bulbs
so, my passenger side turn signal started flashing real fast so i replaced front and rear bulbs in both of them (what a PITA btw). anyhow, is there something else i need to do to get it to stop flashing rapidly?
#2
Did you figure out which bulb was out before you started replacing?
If it's a new bulb in front that's probably not it.
If I remember correctly from doing my girlfriends 01, it's the outside two brake lights that flash. Did you do both already?
If it's a new bulb in front that's probably not it.
If I remember correctly from doing my girlfriends 01, it's the outside two brake lights that flash. Did you do both already?
#3
well the bulb that came out of the front assembly was burnt orange and beginning to bubble and flake. in the rear there was only one bulb that flashes when the turn signal is on and i replaced it
#4
The front bulb is orange coated, but yes they do bubble and flake. As far as the rear, there was only one bulb flashing when it was flashing fast? When it flashes fast, that means a bulb is out. If bulbs were flashing, then they were still good, and I regret to inform you that you changed them for nothing. Turn your drivers side signal on, see what's flashing, compare it to the passenger side, and change the bulbs that don't flash.
Thread
Thread Starter
Forum
Replies
Last Post
Stan
Pictures
9
07-15-2007 09:17 PM
whitethunder46
Show, Shine, and Tunes!
12
11-03-2006 10:55 AM