Go Back  Mustang Boards > Mustang Madness > V6 Tech Forums
Reload this Page >

Replacement of 3.8 liter V6 clutch release bearing

V6 Tech Forums For all your 3.8L and 4.0L needs!

Replacement of 3.8 liter V6 clutch release bearing

Old 12-13-2013, 07:56 PM
Junior Member
Thread Starter
Join Date: Dec 2013
Posts: 4
Smile Replacement of 3.8 liter V6 clutch release bearing

Get a vibration in the clutch pedal at idle and low RPMs. Mechanic told me it was the clutch release bearing. Price of bearing is less than $16, but labor is around $250. Where can I find video/instructions to try it myself?
Old 02-21-2014, 07:15 PM
sand1303's Avatar
Senior Member
Join Date: May 2008
Location: Austin, TX
Posts: 965

its really nothing to it. just have to get the car high enough and have a nice transmission jack. u can undo the driveshaft from the rear end and let it rest on the ground i would guess then just remove your exhaust cat section and it is 4 bolts on the tranny and then the transmission crossmember. don't remove the bell, just the transmission. once you take them 4 bolts out u just slide the trans back with your trans jack and u can reach your arm in there to swap it out. prob a 4-5 hour job with the right tools for your first time
Related Topics
Thread Starter
Last Post
Joe Chapados
V6 Tech Forums
08-03-2011 09:41 AM
Joe Chapados
The Parts Desk
07-31-2011 01:47 PM
The Parts Desk
01-15-2007 05:40 AM
The Lounge
11-10-2006 06:10 PM
General Tech Forum
11-14-2005 11:59 AM

Thread Tools
Search this Thread
Quick Reply: Replacement of 3.8 liter V6 clutch release bearing

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.