Fog Lights WTF!?
#1
06-20-2005 | 10:45 PM
Thread Starter
|
Listen to reggae.
Joined: May 2005
Posts: 10,698
From: Colorado Springs
Fog Lights WTF!?
So I go outside to my car to get a rubber gasket i had left in my car from the shifter install. Just messing around I wanted to see how my lights look against the garage. I turn on the lights and at first dont notice anything, the headlights look great. but no fogs??? I push in the light switch bezel to 1 click (fogs and blinkers) but no fogs!!!!! Whats going on here?? I installed new bubls recently. But they were working PERFECTLY yesterday....and for them to burn out at the exact same time makes no sense. What couldve happened? I'm going to check th bulbs tommrow, but I doubt its them....and to top it off in that 5 minutes I was outside I lost the rubber gasket :mumum:
#2
06-20-2005 | 10:57 PM
Senior Member
Joined: Dec 2004
Posts: 10,237
Check to see if your bulbs are broken. The size 880 is a smaller wattage than your 899. i believe 880 is 27w and 899 is 31 so you could of popped them. replace your 880s with a higher quality bulb or go to 899. Also check your fogs for water inside the lense.
#4
06-20-2005 | 11:07 PM
Senior Member
Joined: Dec 2004
Posts: 10,237
Originally Posted by SpringsStang
The aftermarket bulbs I have in there are 893...and it HAS been raining for the last 2 days....what if there's water inside the lens? are the bulbs still useable?
#8
06-20-2005 | 11:31 PM
Thread Starter
|
Listen to reggae.
Joined: May 2005
Posts: 10,698
From: Colorado Springs
Ok, heres the deal. Its not the bulbs OR the housing. FOr somereason the DONT turn on and the bulbs are fine, I even put the Sylvannias that were in it when i got it, BACK in on both sides. They still dont work. The fuse that controls the fogs, does it control anything else?? This is confusing.
#10
06-21-2005 | 12:01 PM
Senior Member
Joined: Dec 2004
Posts: 10,237
Originally Posted by madmatt
MattJ have you had any leaks with the clear ones?
Better check your wiring then springs, or a fuse. Also take the bulb out, the fillament should be connected, not broken apart. Look for any type of small burn on the bulb near the middle.
#15
06-21-2005 | 04:30 PM
Guest
Posts: n/a
Originally Posted by SpringsStang
heh heh heh ooops :icon_bigs I mustve hit it installing my shifter :laughing5 ...but I still havent found that rubber peice :angry5:
AHHHH HAHAHAHAHAHAHAHAHAAAAAAAHAHAHAHA HA HA HA HAHAHA
HA AHAHAHAHAHAHAH (snort) HAHAHAHA (snort) HAHAHAHAHAHAH SNciker HAHAHAHAHAHAHAHAHAHAHAHAHAHA!!!!!!!!
Phewe.... heh../.. hehehehehe... he he hehehehehahahahHAHA HAHAHAHA HA HA AHAHAHAHAHAHAHAHA AAAAAAAAAAAAAAAAAAAAAAAAHAHAHAHAHAHAHAHAHAHA
Oh man, that is beautiful! <ROFLMMFFAO>
hehehehehehehe Sucker!
#16
06-21-2005 | 04:41 PM
Guest
Posts: n/a
You All Suck!!!!!!!!!!!!!!!!
OK LOOK HERE YOU NUMBSKULLS, EVERY ONE OF YOU! YOU ALL SUCK AT TROUBLESHOOTING!
I cannot freakin believe this! I just read through this whole thread, everyone coming out with thier 2 cents, Check yer bulb size, they must be blown, ARE YOUR FOG LIGHTS FLOODED??? HA HA AH AHHAHAHAHAHA
HOW MANY FREAKIN MONKEYS DOES IT TAKE TO GET A FOG LIGHT SWITCH TURNED ON?????
Apparently NONE of you troubleshoot for a living huh?
As far as im concerned, im the only one here with any laughing rights!
YOU SHOULD ALL BE ASHAMED!
HAH AH AHAHAHAH AHA HAH AHHA HAHA HAHHAHAHAHAHA
YER ALL RETARDED!!!! START WITH THE "ON" SWITCH BEFORE YOU START YANKING FUSES, REPLACING PARTS, OR PULLING WIRES!!!!!!
HA HA AHA HAHAHAHAHAHAHAHAHAHAHAHAHAHAHAH
Well, you all certainly made my day. <rofl> I swear, i laughed so hard i was crying. Phwew
:laughing5
I cannot freakin believe this! I just read through this whole thread, everyone coming out with thier 2 cents, Check yer bulb size, they must be blown, ARE YOUR FOG LIGHTS FLOODED??? HA HA AH AHHAHAHAHAHA
HOW MANY FREAKIN MONKEYS DOES IT TAKE TO GET A FOG LIGHT SWITCH TURNED ON?????
Apparently NONE of you troubleshoot for a living huh?
As far as im concerned, im the only one here with any laughing rights!
YOU SHOULD ALL BE ASHAMED!
HAH AH AHAHAHAH AHA HAH AHHA HAHA HAHHAHAHAHAHA
YER ALL RETARDED!!!! START WITH THE "ON" SWITCH BEFORE YOU START YANKING FUSES, REPLACING PARTS, OR PULLING WIRES!!!!!!
HA HA AHA HAHAHAHAHAHAHAHAHAHAHAHAHAHAHAH
Well, you all certainly made my day. <rofl> I swear, i laughed so hard i was crying. Phwew
:laughing5
#19
06-21-2005 | 07:41 PM
DSG!!!
Joined: Feb 2005
Posts: 3,159
From: Paducah, KY
lol the switch was the first thing that came to mind when i just read all this..
i love that switch, i just hit it when i want to pretend to be a v6 (thats what i usually see at night when i try to tell if its a gt or v6).. i guess it doesn't work too well with the exhaust :confused1
i love that switch, i just hit it when i want to pretend to be a v6 (thats what i usually see at night when i try to tell if its a gt or v6).. i guess it doesn't work too well with the exhaust :confused1
#22
06-21-2005 | 08:22 PM
Senior Member
Joined: Dec 2004
Posts: 10,237
Originally Posted by USMCstang
Man, with all the "LMAO's" in this thread, we must have a bunch of guys walking around without asses now.
It's always the simple stuff that gets ya, huh?
It's always the simple stuff that gets ya, huh?
LMAO!
OH NO, IM ***-LESS NOW!
:confused1
#23
06-21-2005 | 08:56 PM
Thread Starter
|
Listen to reggae.
Joined: May 2005
Posts: 10,698
From: Colorado Springs
Originally Posted by csledd
lol the switch was the first thing that came to mind when i just read all this..
i love that switch, i just hit it when i want to pretend to be a v6 (thats what i usually see at night when i try to tell if its a gt or v6).. i guess it doesn't work too well with the exhaust :confused1
i love that switch, i just hit it when i want to pretend to be a v6 (thats what i usually see at night when i try to tell if its a gt or v6).. i guess it doesn't work too well with the exhaust :confused1