Shift Light RPM setting
What rpm should I set my Raptor Shift light at? I'm thinking 5600 so by the time i shift it will be close to 5800.
|
have the car dyno'ed and see where in the RPM range the power drops off.
|
No money to have the car dynoed now. Underdrive pulleys, line lock, and shift light are going in on Friday, then in the next two weeks i will be getting an Xcal 2 from Modularpowerhouse. If i decide to dyno the car, then i would do it after I got the Xcal.
|
Originally Posted by blownstang
No money to have the car dynoed now. Underdrive pulleys, line lock, and shift light are going in on Friday, then in the next two weeks i will be getting an Xcal 2 from Modularpowerhouse. If i decide to dyno the car, then i would do it after I got the Xcal.
He did my dyno tune and it was WELL worth the $$. |
Originally Posted by zigzagg321
well, you could wait a bit...save up the $$(its not that much) for dyno tuning and have Tim Dyno Tune your car with the XCAL your getting.
He did my dyno tune and it was WELL worth the $$. |
Originally Posted by blownstang
Definitely not driving down to Georgia from Chicago to get a dyno tune for a bolt on car. It would be done here, then I could always send my Xcal and graphs to Tim to have him fix the tune.
|
with your mods anything higher then 5,500 wont do anything. shift it there.
|
When you get the XCal 2 datalog your acceleration rate, thats how you figure out where you should be shifting.
|
All times are GMT -7. The time now is 01:15 PM. |
© 2024 MH Sub I, LLC dba Internet Brands