8.8" rear bearing carrier clamp (torque@)??
#2
03-06-2006 | 03:39 PM
Junior Member
Joined: Jun 2005
Posts: 7
Stole this from A site I used to help me install my gears. Hope it helps...
Pinion bearing pre-load, used 8-14 lb-in .9-1.6 N-m
Pinion bearing pre-load, new 16-29 lb-in 1.8-3.2 N-m
Pinion nut, minimum 140 lb-ft 190 N-m
Ring gear fasteners 70-85 lb-ft 95-115 N-m (in stages)
Main bearing fasteners 70-85 lb-ft 95-115 N-m
Pinion shaft lock bolt 15-30 lb-ft 20-41 N-m
(Metal) Cover fasteners 25-35 lb-ft 34-47 N-m
Pinion bearing pre-load, used 8-14 lb-in .9-1.6 N-m
Pinion bearing pre-load, new 16-29 lb-in 1.8-3.2 N-m
Pinion nut, minimum 140 lb-ft 190 N-m
Ring gear fasteners 70-85 lb-ft 95-115 N-m (in stages)
Main bearing fasteners 70-85 lb-ft 95-115 N-m
Pinion shaft lock bolt 15-30 lb-ft 20-41 N-m
(Metal) Cover fasteners 25-35 lb-ft 34-47 N-m
Thread
Thread Starter
Forum
Replies
Last Post
dannyb785
Forum Feedback and Suggestions
4
01-29-2006 02:05 AM
serum114
Modular 4.6L Tech
17
08-06-2005 11:27 PM
