I finally finished up my project and took it in to get it tuned..i have stock block, and 5.0 rotating assembly and most bolt ons.. I was very impressed with the numbers as well as the tuner. I used Dayton Performace and Ben was the tuner. They were saying they had never seen a 2v car put down those numbers with stock cams and heads.
283.54rwhp and 339.96rwtq.

I am installing 150 shot and going to have it tuned next week...The torque should be crazy..i cant wait...Its good to finally see results of work...Thanks to everyone that gave me tips and let me bounce questions around here.

 

also something i wondered if anyone knew about..they said i was running very rich and they took out all the fuel that the computer would let them. Anyone had this problem...they said it woud free up a few if they could get it to run a little bit more lean, so they could increase timing a few more

 

From what I know, when you cant tweak the computer to your needs, a stand alone computer is usually needed.

 

i might look into that...does anyone know how much that running rich can hurt a tune