Nick, Russ Wilcoxson from Tacoma WA here. I received my SCT tuner from you folks 3/8/06. First of all does it have all the latest updates? As in files for adjustability etc. Second I hope the tune that was sent to me richened up the F/A mixture as my C&L has leaned it out to 13 to 1 already and the JBA headers a little more. Turbo Tech in Tacoma WA is still learning about the SCT so it will be awhile before I can get the car on the dyno. My order # was 34694 and cust ID is 24360. Under SKU it has 38006 and 9400 whatever that is. My car again is an 04 Mach 1 with a complete C&L 85mm MAF and JBA shorty headers and Series 40 Flowmaster mufflers, thats it. Is it safe to load this tune before the dyno?
Thanks Nick I hope to hear from you soon.
Yours truly
Russ W.

 

yes it has all the updates, if you had all those mods when you ordered the tune then they made a tune with those mods in mind, and yes it is fine to load it on without the dyno tune that is what everyone does, just load it on and have fun

 

you are in the wrong section, you should be asking mt not the people on the forums.

 

If its from 3/8 it should be on the latest firmware.

As far as your fuel trim and so forth goes I'll check with Nick and see where he put you at WOT. With the mods he probably did richen you up a bit, but I'll see if I can get a number for you.

 

At WOT and High Load you are at 12.57. Thats just the base trim. There are other factors that can influence that, but at WOT he programmed you where you should be.

As far as less than WOT, you're around 14.64, which is fine because with the mods you have you're probably somewhere around 13 to a low 14.

 

Thanks for the info. I will post what I get on the Dyno as soon as Turbo Tech learns the SCT. Thanks again.
Russ W. AKA 24KMACH