from a stop when i start to accelerate it starts really slow and then it starts to speed up after about 2500 rpms i can't do a burnout(even when i hold the break and i cant get above 2000 rpms) in first gear but i can bark gears going into second for some reason. I am not getting the power i should be at the take off. I was wondering whether what would be causing this....perhaps the timing? I am not sure...Also i would like to know would whether it would be better to just take off both catalytic converters or just replace one that is broken?

 

What mods do you have? some mods can cause some serious powerloss in the lower end. Get some gears, thatll send you flying out of first

 

* 302 bored .30 over
* Ford GT-40 turbo swirl heads
* Ford 1.7 roller rockers
* Ford gt-40 upper and lower intake polished
* Ford 6 qt oil pan w/high flow oil pump
* Ford 3 core radiator
* Ford Cobra computer system
* Ford 24lb injectors
* Motor Craft distributor w/new cap and rotor
* K&N air filter w/motor craft air tube
* Ford E-303 racing camshaft
* Accel super coil
* Ford 100 amp alternator
* Good Year blue hose kit
* Ford Racing red spark plug wires
* Black Magic electric racing fan
* Auto meter fuel pressure gauge
* Summit Racing harmonic balancing damper
* BBK fuel pressure regulator
* JBA Shorty Headers
* Cobra R racing hood w/hood pins
* Mac sub frame connectors
* Ford 343 racing gears
* B&M Hammer Shifter
* Ford aluminum fly wheel
* Weld racing drag light rims
* BBK 65mm throttle w/edlebrock spacer
* Pro Flow 70mm mass air system
* Ford 190LPH fuel pump
* Ford racing aluminum valve covers
* BBK lowering springs
* Ford Racing aluminum drive shaft
* Ford high power mini starter
* Lakewood drive shaft safety loop
* New transmission mount
* Ford racing cross member
* Flow Master American Thunder exhaust w/Mac 3in chrome tail pipes
* Mac H-Pipe w/high flow cats
* TCI AOD

 

The only thing I could see killing your torque is the E303 Cam. But it should make "that" much of a difference, especially with your gears? (did you mean 3.73's? 3.43's are an unusual gear)

Have you dyno tuned it BTW?

 

the guy i bought it from said they were 3.43's so i guess thats what they are and why would that cam kill my torque.......no i have not had it dynoed

 

The E303 Cam makes the peak torque much higher in the RPM band, which is good for increasing HP, but sacrificing your low end torque on the street.