General Tech Forum Use this form for tech related topics that relate to all/most Mustang platforms
Sponsored by:
Sponsored by:

T-45, and T-3650

Thread Tools
 
Search this Thread
 
  #1  
Old 10-15-2005, 01:04 PM
DarkSith's Avatar
Victory Is Mine
Thread Starter
Join Date: Jun 2005
Location: Lake City, SC
Posts: 1,327
Default T-45, and T-3650

Is there any way to tell the difference between the two, while its still under the car?
Thanks
 
  #2  
Old 10-15-2005, 02:09 PM
MattJ's Avatar
Senior Member
Join Date: Dec 2004
Posts: 10,237
Default

I cant speak for the t45 but the 3650 just has a tremec stamp on it underneath. are you looking for the trans in your car?

mid 2001+ is 3650
01-below is t45
 
  #3  
Old 10-15-2005, 02:51 PM
DarkSith's Avatar
Victory Is Mine
Thread Starter
Join Date: Jun 2005
Location: Lake City, SC
Posts: 1,327
Default

Originally Posted by MattJ
I cant speak for the t45 but the 3650 just has a tremec stamp on it underneath. are you looking for the trans in your car?

mid 2001+ is 3650
01-below is t45
Yeh, Im looking for my car. I believe the previous owner of my car put a t45 in it, and I believe thats why my speedo is fast. I wanted to make sure, so I know what I need to get, in order to correct it.
 
  #4  
Old 10-15-2005, 02:56 PM
MattJ's Avatar
Senior Member
Join Date: Dec 2004
Posts: 10,237
Default

Previous owner may have put gears in the car. I doubt transmition was swapped.
 
  #5  
Old 10-15-2005, 04:34 PM
DarkSith's Avatar
Victory Is Mine
Thread Starter
Join Date: Jun 2005
Location: Lake City, SC
Posts: 1,327
Default

Ok I just drove my car down the rode and back, and at 2000rpm my speedo says Im going 75, but Im acctually doing 70. Anyone got an I idea of what gear ratio would cause this.
 
  #6  
Old 10-15-2005, 05:10 PM
MattJ's Avatar
Senior Member
Join Date: Dec 2004
Posts: 10,237
Default

Jack your rear end up and mark the driveshaft to where you can see it take one complete spin. Spin your rear tire one full time and watch how many times the driveshaft will spin

Stock is 3.27 you youll see the driveshaft spin about 3.27 times if those are the gears. Other common ones are 3.55s, 3.73s, 3.90s, 4.10s, and 4.30s.
 
  #7  
Old 10-15-2005, 06:31 PM
Shambles's Avatar
Sigma Beta Rho Soldier
Join Date: Mar 2005
Location: Philadelphia, PA
Posts: 2,682
Default

You can tell what kind of Trans you have in your car many ways.

For example:

Water Pump Pulley:
Short Pulley = 3650
Long Pulley = 45

OR

You can look at your door sticker. Its listed in there as well...

Look underneath the Vin for the TR code...decode it as follows:

Transmission

A 5 character value; the first character indicates transmission type, characters 2-5 indicate spring type, Front/Rear.

Transmission Codes
Code Model
P AODE
T AOD
2 (5.0L) M5OD
5 Five-speed manual, T5OD
6 Five-speed manual, T45OD
U Four-speed automatic (4R70W)
K Five-speed manual, Tremec TR-3650

Anything else you might want to know about that tag is here (94-04)
http://web.tampabay.rr.com/theflock/...doorplate.html
 
  #8  
Old 10-15-2005, 06:35 PM
Shambles's Avatar
Sigma Beta Rho Soldier
Join Date: Mar 2005
Location: Philadelphia, PA
Posts: 2,682
Default

How do you know your doing 75? If your doing 70 then you have a 3.27:1 Ratio, which is stock.
 
  #9  
Old 10-16-2005, 07:56 AM
DarkSith's Avatar
Victory Is Mine
Thread Starter
Join Date: Jun 2005
Location: Lake City, SC
Posts: 1,327
Default

Originally Posted by MTShambles
How do you know your doing 75? If your doing 70 then you have a 3.27:1 Ratio, which is stock.
I got one of my friends to pull beside me. his truck was going 70 my speedo said 75. I've had people do this a few times to make sure it was 5 fast.
 
  #10  
Old 10-16-2005, 11:22 AM
Badfish's Avatar
Listen to reggae.
Join Date: May 2005
Location: Colorado Springs
Posts: 10,698
Default

Originally Posted by MTShambles
You can tell what kind of Trans you have in your car many ways.

For example:

Water Pump Pulley:
Short Pulley = 3650
Long Pulley = 45
That is untrue, because I have the short pulley, but I have a t-45
 
  #11  
Old 10-16-2005, 02:36 PM
Shambles's Avatar
Sigma Beta Rho Soldier
Join Date: Mar 2005
Location: Philadelphia, PA
Posts: 2,682
Default

There were a few that I have seen that were off, i.e. T-45 w/ short pulley. The majority of the cars with 3650's have short pumps though.
 
  #12  
Old 10-16-2005, 03:47 PM
JayC's Avatar
Cage Fighter
Join Date: Apr 2005
Location: Southern Indiana
Posts: 225
Default

The code on the door as mentioned before is a good way to ID the tranny. Also a T-3650 has a drain plug on the bottom where a T-45's is on the side



Jay
 
  #13  
Old 10-16-2005, 04:26 PM
DarkSith's Avatar
Victory Is Mine
Thread Starter
Join Date: Jun 2005
Location: Lake City, SC
Posts: 1,327
Default

Originally Posted by JayC
The code on the door as mentioned before is a good way to ID the tranny. Also a T-3650 has a drain plug on the bottom where a T-45's is on the side



Jay
Cool, tomorrow I'm going to check for the drain plug thing, and check the drive shaft to see what gears I have. Maybe I will find out why my speedo is off.
 
  #14  
Old 10-17-2005, 08:29 AM
rada's Avatar
Senior Member
Join Date: May 2005
Location: Brea, CA
Posts: 270
Default

Originally Posted by SpringsStang
That is untrue, because I have the short pulley, but I have a t-45
Ditto - short + T45
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
midnightblueGT
General Tech Forum
17
08-24-2007 01:17 AM
Markstung70
General Tech Forum
2
06-23-2007 09:31 AM
resq1
Modular 4.6L Tech
13
11-20-2005 08:12 AM
4.6 Love
Modular 4.6L Tech
12
06-03-2005 02:16 PM
big lou
Modular 4.6L Tech
8
09-24-2004 08:54 AM



Quick Reply: T-45, and T-3650



All times are GMT -7. The time now is 07:18 AM.