Any one with mac long tube headers
 

i've got a v6 and i was wondering if anyone who ordered the mac lt headers ran into problems while installing them? or any other suggestions on the topic would be helpful

Well when I installed a pair on a friends car we had pulled the old single port v6 (94-98 motor) out and added the long tubes to the new 00 v6 split port motor and we installed the headers with the tranny, motor, everything on it. It wasnt hard and I dont see it being to tuff to get them out with the motor in the car if you just jack the engine up a bit. We didnt use the EGR as the new motor didnt come with it so we capped off the EGR port with a pipe cap and some JB Weld. Overall nice product and added some good power to that motor.

if you were to replace the headers I would go with the LT's. It's not worth it to replace the headers with shorty's

yea, well i heard about the gts rubbing the starter and was wondering if the v6 did it, but another question.. what are the top 2 tubes off of the right header and the one on the left?