97 gt pi nitrous
i wrecked my 97 it was a pi motor pi heads milled and smoothed with modular powerhouse stage 2 cams still intake accufac plenum and t-body. ill be putting the motor in a rolling chassis 97 cobra im wondering if it is safe to spray any even a small lilttle 50 shot? im also in need of long tube headers and x-pipe if anyone has some let me know. im planning on sonic blue with 18 in saleen rims, given that the 3 good ones on the car i wrecked are still good. would that look right?
|
yep. shoot it dry.
|
This belongs in the power adder section. Moving......
As per your question, of course you can spray it. Nitrous loves compression and I'm sure even with your milled heads (I have no idea how much they cut them) your still going to be fine. You can spray much more then a 50shot and fuck dry nitrous kits. But that part is just my opinion. |
50 is too small to bother doing wet. The injectors can pick up for that 50hp better than the tiny ass orifices on the nozzle will mix it. 75+ go wet but at 50, dry shoot that bitch.
|
So its ok to spray it even thought it has stock internals?
|
75 wet shot :D
|
Originally Posted by ponyexpress
(Post 448971)
So its ok to spray it even thought it has stock internals?
Colder plugs, only spraying at WOT.. |
Yes I have a 125shot on my stock long block from Ford with 60k miles of nitrous use. A good setup, proper fuel, and use and you will be ok. A tune helps too. But I was untuned for years with a 125 shot. Of course your setup is a little more touchy with the extra compression.
|
All times are GMT -7. The time now is 08:29 PM. |
© 2024 MH Sub I, LLC dba Internet Brands