problems with the old whip
 

hey everyone! this is my 2nd post 1st would be in the newb section lol but my prob just started happening yesterday morning, i woke up a little early to start my car and let it heat up b/c for sum reason it was like 20 degrees in south jersey this morning after being like in the 60's the past couple days, so after i put my car in reverse i put my foot in the gas and my car doesnt go anywhere, i can feel it trying to go but it wont after like a 30 seconds it just keeps bucking, and when i actually start going its hard for it to accelerate, it use to accelerate nice because of the gears lol but yesterday and today it was just moving so slow and when i would come to a stop at a light, when i would go it just keeps bucking i actually put my foot all most all the way down on the gas and it would go like 5 miles and hr whats wierd is th rpms would go up but the it would around 5mph, can sumone help me its drivin my nutz!!

Are you running the stock MAF, or do you have an aftermarket intake?

stock maf and k&n fipk intake

betting it's an auto tranny... I'll venture to say the tranny or torque converter is hammered (possibly the tranny pump). If it's a manual... then your clutch is probably shot. Thing is... clutches usually fail kinda gradually so that's why I bet you drive an auto trans car.

Good luck.

hmm my tranny huh, is there a way i could be sure that is the prob besides takin it to a tranny shop? and if it is the tranny since im doing heads, cams, and intake should i go with a stall converter or maybe a stock pi converter?