My dyno results!
 

I'd like to start off by thanking everyone at DynoSpeed Racing and MT!!

So I drove 150 miles to Dyno Speed Racing located in Memphis, TN to run on their Dynojet and get a tune from an SCT Xcalibrator 2. When we got there we did a pull in 4th gear and the car put down 257.49 HP and 284.81 TQ and the A/F line was right below 15 (ouch!). We they loaded up the tune through the Xcal 2 and the car cooled and we were ready for the next run. When he shifted to 4th it acted like there was no 4th gear, the car didnt respond to it at all. It would let you shift into 4th but you could have the pedal all the way down and nothing. So they talked to SCT, messed around with the tune, and tried again. Same results. So they loaded the stock tune, even worse results. Thankfully it threw a code and it was traced back to the TPS (I knew that thing would cause me problems). It was bad so we ran to Ford to pick up another and all was well again. The final run put down 270.77 HP and 306.68 TQ. I'm happy with the numbers because I predicted 270, A/F was right around 13. Attached is the dyno graph and a pic of my car :) The blue lines are from the first run with the stock tune, red is with SCT Xcal 2 tune. All mods are listed in my sig.

http://www.csledd.com/ellie/dynosheet.jpg

http://www.csledd.com/ellie/atdsr.jpg

here is the stock run video: clicky


here's what your car sounds like when 4th gear doesn't work :): clicky 2

Nice numbers! Beats the crap out of my heap.

lol now if i could just run your track time :p

Sweet! How much did the dyno run cost?

had to pay $90 dyno rental fee and then they charged me $150 for tuning. Which is very good because most places charge you by the hour for tuning and that would've been hella expensive :)

Where did you buy the sct2 from? how long were you on the dyno for?

they held one for me, ended up being on the dyno for about 3 hours. they said tuning gts is very easy and it shouldn't have taken that long, but we had to troubleshoot that damn TPS problem and then replace it.

Nice numbers,definitely going to have to get a dyno done and my other mods done.

cost me $300 at EJ's in Omaha for a complete blower tune :)

I already had the xcalibrator

Congrats on the awesome numbers.