Mustang Boards

Mustang Boards (/)
-   General Tech Forum (https://mustangboards.com/general-tech-forum/)
-   -   3.73 gear prob? (https://mustangboards.com/general-tech-forum/15333-3-73-gear-prob.html)

stevestang81 06-29-2006 04:37 PM

3.73 gear prob?
 
sorry for borthering all u about this again, but as i said before i feel little if no difference after installing the 3.73s. is there any way the shop incorrectly installed them or screwed me over by not installing them at all?? like how would i ever know if he actually just ripped me and kept the old ones in?

steve

03gtmustang 06-29-2006 05:22 PM

Im pretty sure you can count the # of teath on the gears and figure it out?

NoKturnaL 06-30-2006 12:52 AM


Originally Posted by stevestang81
sorry for borthering all u about this again, but as i said before i feel little if no difference after installing the 3.73s. is there any way the shop incorrectly installed them or screwed me over by not installing them at all?? like how would i ever know if he actually just ripped me and kept the old ones in?

steve

ask him for the original gears that he TOOK OUT.

phatpony 06-30-2006 04:12 AM

Block your front wheels and jack up the back of your car so that both wheels are off the ground. Put it in neutral. Mark your rear tire to some reference point where you can tell when it has turned 1 revolution. Mark your drive shaft and rearend where they meet. Now rotate your back wheel exactly 1 turn and count how many times the driveshaft turns. If it is just over 3 times you likely have the stock gears, if it turns almost 4 times (3.73 to be exact) you got your new ones.

dookie2365 07-02-2006 11:16 AM

yea should always get stock parts back......by now he prob threw em out if he did rip u off or sold them or soomething

MattJ 07-02-2006 11:21 AM

If the car had a previous owner, mabye they already had 3.73s in there...

zigzaggthefag321 07-02-2006 11:56 AM

i felt the difference, and i got my old gears back without asking...i found them in my trunk a few days after the install...didnt even know they were there...lol

Id ask the shop for your old gears back..or do as phatpony said.

lizardbreath 07-02-2006 01:01 PM

You should have felt a slight increase, if not then it sounds like you got ripped off by this asshole.

stevestang81 07-02-2006 01:33 PM

well, i got the gears back...and they were def 3.27s cause its engraved on the gears. anyway, i guess i expected a bigger gain (acceleration) b/c the gears are def installed.

first off, my rpms are higher (i redline quicker in every gear), secondly, im on the highway and my speedometer says like 85/90 while im going with the flow of traffic so something is obviously different.

im gonna get a my speedometer recalibrated and then i'll use that gear formula just to verify the change.

now that i have the 3.73s, though, i probably would have gone with the 4.10s

steve

liv4him 07-03-2006 01:37 PM

I just got my 4.10s in and love them, glad I did'nt go any lower. Tell you the truth if I ever redo them I might be tempted to go with 4.30s.

Lances03SVT 07-03-2006 01:41 PM


Originally Posted by liv4him
I just got my 4.10s in and love them, glad I did'nt go any lower. Tell you the truth if I ever redo them I might be tempted to go with 4.30s.

No doubt!!

If I ever did them again 4:30's would be the one for sure :beerchug:


All times are GMT -7. The time now is 10:05 AM.


© 2024 MH Sub I, LLC dba Internet Brands