Had a thought.
 

I have been looking forever to find a good deal on a hood scoop. and it always ends up somone wants too much for it, or I am a little late on getting the deal. So, I was wondering how much modification it would take to make something like a scoop from a late 60's early 70's Mustang to fit? I like the look of this one below but I don't know how much it would take to fit it?

What ya think?

https://i19.ebayimg.com/03/i/06/fd/4a/a5_12.JPG

i doubt it would be that much work depending on the width... the question is would it look right...

http://cgi.ebay.com/ebaymotors/FORD-...62970774QQrdZ1

http://cgi.ebay.com/ebaymotors/01-02...63089290QQrdZ1

there's no way to affix that to the hood securely enough that doing 90 won't send it immediately to the rear of your car. Bad plan. Swap hoods with someone, that's the easy way.

they make a 2 parts epoxy body shops use, problem is youd have to sand the hood, once you put in down with this stuff and it dries there is no moving, then youd have to sand, fill, sand, prime, paint, like he said get a hood, alot less trouble,

There is a Mustang around here with some aftermarket scoop on it and it look's nasty.Keep looking for the regular scoop!!