Hey does anyone know how to swap out the stock projector light bulbs? I just bought the PIAA H1 & H3 bulbs but im having a hard time taking it apart...

 

reach behind the lamp and twist and pull. youll feel when its ready to be pulled out. it should take you 30 seconds to do both.

 

do i have to take out any of the screws inside the shell???

 

--------------------------------------------------------------------------------

do i have to take out any of the screws inside the shell???

 

It is really simple. Did you figure out how to pull the head light unit out yet? You need to do that first, then unplug the wire harness going to the bulb. Then twist-off the plastic holder that holds the bulb and pull the bulb out.

 

yea on the projector lamp theres a cover with three (maybe four) screws. The h3 bulb has a set screw that holds a latch down. loosen that then theres one white wire that goes to the bulb that you pull to disconect....put the new bulb in and screw back on the set screw and back plate and your set

ummm the high beems i have no clue how u reach though so good luck on that one??