Need 1990 GT exhaust help
New to Mustangs and need someone with experience. I need to replace the exhaust on my 1990 GT. The way I understand it the car came with factory headers but from what I am finding the studs break? Am I right about that?
Would like to replace with new headers and a complete exhaust. Has anyone done this and what did you use for the headers and the complete exhaust. Any help would be appreciated. Thanks |
long tubes will make most power and that requires a new "shorty" mid pipe for long tubes then whatever catback suites you. YOu dont need 3" unless you are pushing lots of power think 500+.
|
thanks for the info
I appreciate the help
|
my car already had exhaust on it when i bought it. shortie heads will do you fine till 450 hp. but long tubes will give you an extra 10-15 ft lbs of torque... at least. unless your on a super budget, i would pick up a set of used long tubes with mid pipe, then use header paint/header wrap on them. i have bare shorties and the engine bay gets really warm and it sucks pulling that into the motor. after that its personal preferance. 2.5" will be plenty. mine was bent up by an exhaust shop with flows. i think the summer branded cat back is less then $200 shipped. you can do the whole exhaust for less then $600 w/ long tubes if you take your time and pick the right parts off the internet.
anything else just ask man! |
Thanks
I appreciate the information sounds like the way to go with the long tubes.
|
Originally Posted by thehdman
(Post 268796)
I appreciate the information sounds like the way to go with the long tubes.
|
All times are GMT -7. The time now is 02:25 PM. |
© 2024 MH Sub I, LLC dba Internet Brands