headers ??
 

ok i need to change my headers because the oem on the car are bad i went to the muffler people they said one of the header in the driver side is licking sound and i will cost me around 100 to 150 to fix it so i was thinking to buy new one's.i dont know anything about headers so i need help i have a convertible.All info is in bottom.

it all depends on what you wana spend and what you want out of them. so what do you want, more power, sound, looks, are you planing on uprading to a new egsost?

well more power i have a exhaust with flowmaster

go to summit.com or jegs.com and look at what will fit your car, and what will fit your wallet. i would go with a full length header from hooker.

ok i will check them out thx for help

i have no idea but are the stock ones short or long and when you replace them to put on a new exuast system which are better?

stock headers are short and its hard to say which are better for you because they do diffierent things so it depends on what your lookin for

let me say this if all it is is a leak then dont waste your money on new headers just have it fixed.

Why buy new headers. they are going to cost you around 400 or more then you have to have them installed which is at least 300 so IMO pay the 150 and fix it.

600 buck for 4 hp no thanks
rant ended

Problem I have heard with some of the 00-04 v6's is that the headers have a flaw (normally passenger side) and will actually wear away so badly it'll break.

Breaking = exhaust dragging

Something about how the welds were done. I dunno, my buddies had that.

Mine was apparently getting to that point, and they said it would be better to just replace them. So I did. Went with headmans...and since i can't pass smog with long tubes, I had to go with the shorties :(

ya u right i should just fix it its cheaper. Thx for the help

go with short tube headers. the long tube headers requiere the 3.8 engine to be lifter a little i believe.

is it possible to get a true dual exaust with shortys?

have you considered just tightening the nuts on the manifold. THat's probably how it started leaking cuz ain't no shop in the WORLD gunna pull and replace mustang headers for 100 bucks. It's a several hour long job in the best of cases.

yeah, its just the same as if your car was stock

Is installing headers something you can't do yourself?

no you can do it yourself. tons of people have just gotta take your time since it can be a pita

he was being sarcastic

ah didn't catch that should have added a :rolleyes: haha