H&r
 

well today i put the springs in...no problems until the last one. when i lowered the car back down the back right springs sits higher then the left side. so i dont really know what to do to fix this problem, anything im doing wrong??

Did you install the springs the exact same way on both side's??

yepp had both the lower ends of the springs facing the driver side...do you think it might settle out in a little bit..its about a 1/2-3/4 inch difference

Hmmmmmmm Yea they should.Mine were even though.

ill see how it looks in a week...other then that small thing, the car rides great

pull out 1 isolator. Then it'll be even.

I used the 2 MM isolators on each rear spring. Its even and the bottom spring tips both point to drivers side. You didnt leave out an isolator did you?

everything was put back in...today it settled a little more even, so its looking better...wouldnt takeing out and isolater make the ride alot harsher?

It wont really make it harsher. But it MIGHT give you some extra noise.

I took out the isolators on my 95 and didn't hear anything and it wasn't harsh.

so i do take out the bottom or top one....the back right side of the car is sitting about a 1 1/2 finger widths higher then the left

Id take out the bottom one to start.

if the bottom isnt enough should i put that back in and take the top out ..or jus take out both...