Mach 460 Speaker Covers

jjtgiants · 01-06-2005, 02:33 PM

Hello all! I'm new to Mustang Tunings forum, however I decided to join because I've had such good experiences with Mustang tuning and everyone seems friendly on this website. I do have a quick question:

Does anyone here have the MACH 460 Billet Aluminum Satin Front Speaker Covers With GT Logo??? If so were they hard to install? I was looking at the stock speaker covers the other day and it didn't look like a big deal to do, but I don't want to start popping stuff off with a screwdriver cause things are never the same after doing that. Thanks in advance for any response.

04GTMikey · 01-07-2005, 08:36 PM

I've got the billet w/o GT logo and it's easy peasy to install. Just pop off your factory ones with a screwdriver and snap the billet ones on. They are grooved on the inside so you just have to push them into place. Takes a little strength but not much.

jjtgiants · 01-08-2005, 11:14 AM

Thanks 04GTMikey I really appreciate the help. I'm not sure if you have the Bullitt pedals on your mustang, but I was told they were easy to install....and after several F bombs and frustration I finally got them on, but now I'm careful about the "easy to install parts". Thanks again.

01-06-2005, 02:33 PM	#1 (permalink)
jjtgiants jjtgiants Join Date: Jan 2005 Location: Dublin, CA Posts: 3,762	Mach 460 Speaker Covers Hello all! I'm new to Mustang Tunings forum, however I decided to join because I've had such good experiences with Mustang tuning and everyone seems friendly on this website. I do have a quick question: Does anyone here have the MACH 460 Billet Aluminum Satin Front Speaker Covers With GT Logo??? If so were they hard to install? I was looking at the stock speaker covers the other day and it didn't look like a big deal to do, but I don't want to start popping stuff off with a screwdriver cause things are never the same after doing that. Thanks in advance for any response.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fuel regulators	HappySavage	Modular 4.6L Tech	16	12-03-2006 08:03 AM
Order #40719	svtsnakebitn	Order Status ?'s	1	05-11-2006 08:40 AM
Hesitating Stang	Slither	General Tech Forum	5	04-29-2006 07:36 AM
2.4 KB 2005 GT vids	Acts26:20	Videos	10	01-17-2006 05:05 PM
Lowering springs and traction	silvergt	General Tech Forum	6	11-11-2005 04:41 PM

01-07-2005, 08:36 PM	#2 (permalink)
04GTMikey Stang Maniac Join Date: Dec 2004 Location: Dallas, TX Posts: 170	I've got the billet w/o GT logo and it's easy peasy to install. Just pop off your factory ones with a screwdriver and snap the billet ones on. They are grooved on the inside so you just have to push them into place. Takes a little strength but not much.

01-08-2005, 11:14 AM	#3 (permalink)
jjtgiants jjtgiants Join Date: Jan 2005 Location: Dublin, CA Posts: 3,762	Thanks 04GTMikey I really appreciate the help. I'm not sure if you have the Bullitt pedals on your mustang, but I was told they were easy to install....and after several F bombs and frustration I finally got them on, but now I'm careful about the "easy to install parts". Thanks again.