tach signal
i cant seem to get i tach signal for my window switch ...i need help i have a 96 gt any help would be great
|
I know its one of the wires going to the coil pack. Gotta check them to find the right one.
|
which side ..the drivers side or pass. i tried both of the neg wires on drivers side . i looked up how install a aftermarket tach and it said to get a signal from the tach in the clucter . it didnt seem hard to do .. do you think that would be ok?
|
I'm sure you can do it that way, but my MSD window switch is in the engine bay so I didn't see a reason to get it from inside the car when the coil pack is right there. You should be able to get a coil signal from either coil pack. Just have to use a manual or tester and find the correct wire. That's what I did when I did mine. But I have C.O.P. not coil packs so I can't tell you which one.
|
i finally got all of the nitrous stuff installed .. but when i opened to bottle the pressure only went up to 600 psi its is only about 40 outside right now where i live ..could i still use it with only 600 psi?
|
Yes, but its going to be super super rich. Take the bottle inside turn the shower on full hot and heat that bottle up.
Oh and get a damn bottle heater. The Compucar ones are like $45 for them. But I have done the shower trick before I had a heater lol. Just be sure to of course dry it off. |
thank you for answering all of my questions ....you have been very helpful .
|
No problem that's what this place is for to help each other and learn. I mean I didn't know a whole lot not to long ago. You gotta post how you like it once you use it!
|
i got a warmer .. where do i get power ...any hot wire?
|
i got a warmer ...where do i get power from ? just any hot wire ..or tap into fues box ...any help would be good.
|
Mine is setup so that I don't ever leave the heater on by accident. So its wired to the same 12v switched source I used for the nitrous kit.
|
All times are GMT -7. The time now is 06:01 PM. |
© 2024 MH Sub I, LLC dba Internet Brands