Procharger D1sc
anyone running a D1 and if so what size pulley do you have and what boost numbers are you seeing?
just trying to figure out the size pulley i need for about 18-20lbs of boost :) |
I run a 3.4 and see about 13lbs. D1SC.
|
i got an 8 rib setup with a 10% overdrive crank pulley (Innovators west) and i've ordered a RR 3.0 pulley and i'm hoping that will be enough to see 20's.. =/
|
Originally Posted by Bwhipple
(Post 358889)
I run a 3.4 and see about 13lbs. D1SC.
|
The D1SC is a little bit more efficient, makes more boost at low RPMs, and can be spun faster without extreme heat.
|
i think i'll hit my goal on the 3.0 pulley i'm just trying to get mid 600 hp really.
i'm currently looking at blower cams, maybe AFM but i can't decide really |
Originally Posted by Bwhipple
(Post 359655)
The D1SC is a little bit more efficient, makes more boost at low RPMs, and can be spun faster without extreme heat.
with the same size pulley the D1-sc should make more boost. or a bigger pulley to make the same boost. |
I see over 13lbs on the 3.4. Slippage maybe? You will need a 2.8 to see 20lbs on a D1SC.
Usually the 3.2 on a P1SC is good for 13lbs not 15. Are you using a power pipe or spinning it faster than 6k? |
Originally Posted by Bwhipple
(Post 360904)
I see over 13lbs on the 3.4. Slippage maybe? You will need a 2.8 to see 20lbs on a D1SC.
Usually the 3.2 on a P1SC is good for 13lbs not 15. Are you using a power pipe or spinning it faster than 6k? are kits come with a 3.6 pulley which is 11psi kit. |
All times are GMT -7. The time now is 04:44 AM. |
© 2024 MH Sub I, LLC dba Internet Brands