03BullittClone

My car is street/strip with a stock suspension. It drives me crazy to feel the suspension "eating" HP that should go to the ground. My problem is this; with all the various things I can do to upgrade the suspension, I don't know where to start. Keeping in mind my use is street/strip, where can I get the most bang for my buck?

__________________
Looking REAL Hard at an '06 Shelby!!!

stang5

LCA'S and Subframe connectors is where you should start, you'll improve the weight transfer when you launch your car

__________________
02 GT 5 speed N/A
262 RWHP-300 RWTRQ

mike sweeney

I have heard a lot of good things about the FRPP upper control arms. they will tighten up your launch and reduce wheel hop. they have stiffer than stock bushings but they are not so stiff that they cause axle bind. And probably the best part you gan get them usually for under $80 shipped.

__________________
2004 Torch Red GT
Flowmaster Am.Thunder cat back, SLP Mid Pipe
Steeda Underdrive pulleys
3.73 gears
Diablosport Predator tune
Grille Delete and Mach 1 spoiler
Rear Wing delete
Mustang Tuning Shifter
Bullitt Handling Kit

WaterDR

03 Bullet:

Off topic, where in suburban chicago are you from?

__________________


Black 2000 GT Vert: Novi-2000 with Intercooler (375rwhp @ 9 psi); Tune by Kauffmans; Roush 380R Body kit; Steeda Subframes; Steeda Strut Tower Support; Deep Dish Bullets; FRPP 4:10's; SCT 4 Position Chip with four custom tunes; Steeda CAI; C&L Pleum; BBK 75 TB; SLP Loudmouth; SLP Catted X-Pipe; Bullitt Suspension; UPR Conrol Arms; Focus Fuel Pump

My Car

My Email

03BullittClone

50 mi. NW of downtown. But I work downtown.

__________________
Looking REAL Hard at an '06 Shelby!!!

WaterDR

I asked because I grew-up put there. Wheaton. Have sister in Naperville, brother in the city, and sister and Mom up NW of the city. Near Barrington....a little place called Round Lake I beileve. Also another brother in GlenDale Heights I think. He just got married and moved so I am not sure.

in case you are counting, I have seven siblings with two more in CA.

__________________


Black 2000 GT Vert: Novi-2000 with Intercooler (375rwhp @ 9 psi); Tune by Kauffmans; Roush 380R Body kit; Steeda Subframes; Steeda Strut Tower Support; Deep Dish Bullets; FRPP 4:10's; SCT 4 Position Chip with four custom tunes; Steeda CAI; C&L Pleum; BBK 75 TB; SLP Loudmouth; SLP Catted X-Pipe; Bullitt Suspension; UPR Conrol Arms; Focus Fuel Pump

My Car

My Email

madmatt

Id definately go for some lower control arms and the uppers would be nice too since they are cheap. Pro3i makes some that id prolly buy. www.partshopper.com sells them. They are pretty well priced as well. The steeda ones are ok too I hear. The only negative thing is that ive seen a pic where one broke. Subframe connectors are a must as well.

__________________