So no one has bought/installed a set of PYPES Longtubes for 96> GT's?
:confused::confused::confused::confused::confused: :confused::confused::confused:
|
17 Attachment(s)
Installed pix:
Attachment 22155 Attachment 22156 Attachment 22157 Attachment 22158 Attachment 22159 Attachment 22160 Attachment 22161 Attachment 22162 Attachment 22163 Attachment 22164 Attachment 22165 Attachment 22166 Attachment 22167 Only problems to report are the first joint on the steering shaft just BAAAARLEY contacts one of the primaries while turning. It's not knocking on it by any means, but you can hear it slightly tap two or three times during a turn. This is most likely due to my changed up front suspension geometry(offset rack bushings) I tried rearranging the bushings a little bit and got a little bit more clearance, but I think it'll be OK. I don't have a gigantic flathead pry bar, so I may go pick one of those up and just give the primary a little flat spot and resolve the issue. The other problem/issue, is the EGR tube(you can kinda see it in one of the above pix). Apparently I twisted it a bit while putting it on the new connector. :confused::confused: I don't see any signs of leakage, and I tested it and the tube was not blocked off...so who knows. I'll block it off it becomes a problem. Not really a problem, but I did wedge a big flat head between the floor pan and the drivers side collector flange. It wasn't making contact, but I wanted just a little bigger tolerance. All in all, after all the horror stories i've read on the internet about fitment, I feel I got lucky with these as they certainly seemed to "fit", but just getting them up there was the frustrating part. Another thing that popped up while doing all this bullshit was that my power cable from the front to the back where my battery is was hitting on the drivers side header. :mad: I relocated the cable, drilled a hole, used a grommet and some split heater hose and zip ties and took care of that issue as well. Attachment 22168 Attachment 22169 Attachment 22170 Attachment 22171 |
have you felt any gains or will you be gettin dyno?
|
I probably won't DYNO the car, but it certainly has alot more top end. It's not one of those "I think it has a little more power", it's "Good God! This thing really pulls up top! :eek: "
I've got a wideband 02 on the car and I'll just monitor the A/F's and make sure things will be OK. I haven't tried the nitrous yet with the tubes, but i'm sure it'll feel GREAT!! |
are you running an h or x pipe
|
I have been running an H-pipe, but the shorty PYPES H-pipe for a 100 bucks was a good deal(especially since it's stainless steel), so I ordered it yesterday.
I know the X pipes probably make more top end power, but I like the old musclecar sound of the H-pipes. I'll take the 2-3hp hit from the H over the X ;) |
Sounds like alot of problems with your install. Are the headers on the starter at all because it looks like they are sitting on it almost.
|
Alot of problems?! Are we reading the same post? I guess the headers didn't install themselves, but it went on fairly well. Having to massage a couple area's isn't that big of a deal at all(to me at least). I've read about people not even being able to get them installed or having to heat parts of the header to make it fit.
As for the header primary and the starter, there is about a 1/4" space, or maybe the width of a pencil. It's alright. |
All times are GMT -7. The time now is 04:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands