Best springs?
Hey guys. I want to lower my stang a bit, and I was curious as to what springs and shocks u guys are running. I dont want to go too low, but i dont want the 4x4 look anymore as well. Whats the best for the price? which hold up the best and which give the best ride? thanks!
|
I have Eibachs which is 1 1/2" drop and I recommend you upgrade your shocks if going this low or lower. I have a nuclear reactor in my trunk so it adds weight to the back therefore its a bit lower. I hit speed bumps all the time if I dont go slow enought. I bought some ureathane isolators to see if it will raise it a bit. If I had to do it again I would get the steeda springs which lower 1 1/4 ". If you plan not to have anything in the truck then you might be ok with 1 1/2".
|
I am probably going to go with the Ford C-springs and Mach 1 shocks and struts. This is about a 1 - 1.25 in drop so most dont need C/C plates. Thats coming up soon. :D
|
Originally Posted by madmatt
I am probably going to go with the Ford C-springs and Mach 1 shocks and struts. This is about a 1 - 1.25 in drop so most dont need C/C plates. Thats coming up soon. :D
|
Originally Posted by Jeremy
Same here, I have had my eye on the C springs for some time now. I like the look without going to low.
this is what I have and I love the look of the front, but not the back so much. I have taken care of this problem by cutting the deal coil on top of the rears. There is no difference in ride quality BTW after doing this. |
Originally Posted by millatime
this is what I have and I love the look of the front, but not the back so much. I have taken care of this problem by cutting the deal coil on top of the rears. There is no difference in ride quality BTW after doing this.
|
i am using a pair of maxspeed springs 2" front 1.8" rear, I have had them on for about a year and have had no problems with camber or toe, tire wear, or shocks or struts, and car still rides like the day i drove it off the dealers lot!
|
Originally Posted by Jeremy
Sweet. Did you install the springs yourself? I am going to attempt to go the DIY route. If I get them I will get the dead coil cut like you did. Thanks for the reply.
|
I just replaced the spring isolators this morning. Original ones were torn up. Got the urethane ones and it is a little higher. Went over a couple of speed bumps with no problems.
|
All times are GMT -7. The time now is 10:42 PM. |
© 2024 MH Sub I, LLC dba Internet Brands