Stupid door dinger alert

[MineralGT]

I finally got rid of the litle bing bing bing bing bing crap when my door is open and the radio is on. I like to listen to the music while aI wash my car and found a way to do that with out the beep...also my seatbelt reminder doesn't ding anymore.

[MattJ]

OK, you gonna tell us? I already know just to unplug the seatbelt clip from the bottom peice to remove the seatbelt ding ding ding ding.

[Slither]

actually if you just turn your key forward it turns off after about 10 sec. If you turn it backwards it stays on the whole time.

[MineralGT]

Originally Posted by MahnotinkneeGT

actually if you just turn your key forward it turns off after about 10 sec.

Yeah...but then it comes back after a few minutes...ok instructions:

Door Dinger: by the fuse box near the clutch there are 3 connectors, 2 black and a long white one I think. pull out the white one and on the side with the clip in the middle is a black wire with a purple stripe...make sure you are looking on the side with the clip...cut or remove that cable and that's it...takes about 2 minutes and has no effect on any thing but the dinger. The belt thing takes a while...I'll post it later...I'm at work.

[Slither]

Originally Posted by MineralGT

Yeah...but then it comes back after a few minutes

Mine doesn't. Oh well I guess different years are different?

[macs03GT]

to get rid of mine i had to click my seatbelt in and out a few times, turn the car on but not start the engine. Turn the lights on and off 3 times, then do the same thing again, wait 10 seconds, and do the seat belt again...something like that. It was weird and i didn't think it would work. But for some reason it did. LOL

[Lances03SVT]

Originally Posted by macs03GT

to get rid of mine i had to click my seatbelt in and out a few times, turn the car on but not start the engine. Turn the lights on and off 3 times, then do the same thing again, wait 10 seconds, and do the seat belt again...something like that. It was weird and i didn't think it would work. But for some reason it did. LOL

Yep it shows how too do it in the manual.

[Badfish]

Yep, thats what I did, stait from the manual

[MineralGT]

Originally Posted by SpringsStang

Yep, thats what I did, stait from the manual

Yeah...you just have to do it in like 90 seconds or something like that.

[CCM]

Originally Posted by MahnotinkneeGT

actually if you just turn your key forward it turns off after about 10 sec. If you turn it backwards it stays on the whole time.

Yeah, but you really shouldn't leave your car in that mode if it's not running. It'll drain your battery a lot faster.

[Badfish]

here:

"Belt Minder Deactivating/Activating

Preparation

Before deactivating/activating the belt minder, set the parking brake.

Place the gearshift in P (Park) (automatic transmission) or the neutral position (manual transmission).

Place the ignition switch in the OFF position.

Close all the vehicle doors.

Unbuckle the driver safety belt.

Place the parklamps/headlamps switch in the OFF position. (If the vehicle is equipped with Autolamps, this will not affect the procedure.)

Deactivating/Activating

Turn the ignition switch to the RUN position. (Do not start the engine.)

Wait until the safety belt warning lamp turns off. (approximately one to two minutes)

NOTE: Steps 3 through 5 must be completed within 60 seconds or the procedure must be repeated.

Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled.

This portion of the procedure can be done before or during belt minder warning activation.

Turn the parklamps/headlamps on then off.

Buckle then unbuckle the safety belt three times ending with the safety belt unbuckled.

After this step the safety belt warning lamp will be illuminated for three seconds.

Within seven seconds of the safety belt warning lamp turning off, buckle then unbuckle the safety belt.

This will enable the belt minder if disabled or disable the belt minder if enabled.

The following sequence of events confirm the belt minder is enabled:
flashing of the safety belt warning belt lamp four times per second for three seconds
three seconds with the safety belt lamp off
flashing the safety belt lamp four times per second for three seconds again

The safety belt lamp flashing four times per second for three seconds provides confirmation that the belt minder is disabled.

After confirmation, the deactivation/activation procedure is complete.

Hope this helps"

[mustangV6_04]

or you can do what i did, cut the belt clip off of a mustang at the junkyard and clip it in!