Removing 'GT' Badge?
 

How do I do this on my 01?? Ive heard the GT on the trunk doesnt have any screws and doesnt leave holes? So how do I take it off and not mess up the paint

Heat it up with a hair dryer and use like fishing line to slide underneath it.I could be wrong though.

thats wat i did...but make sure u heat it up for like 10 mins cause ull cut urself if u dont heat it up enuf....take it from a victim of the fishing line

does this leave any adhesive left behind on the car that has to be cleaned off?

Just a little. Use a little bit of adhesive remover.

i left my GT emblem on but took my Ford emblem off nd replaced it with the SCT emblem that came with the tuner, looks hot. ppl sometimes mistake the SCT for SVT and when they see my window column gauges they automatically assume supercharger - i like it!

I took the side GT emblems off my 98. I used a screwdriver to very carefully pry them off. They did leave a hole but I didn't care because I was putting on a different one anyway. The trunk on however, will not have a hole under it. Also keep in mind, if your car's paint is faded at all, you'll be able to see where your emblem was. Oh, and take your time.

Your all frikkin idiots. Why the hell would people wanna remove the GT badge?
Wha ya gon do? put a cobra badge on instead? bah hum bug.

your a tard :p ....just leave it smooth to make it more streamline...eventually im going to get my wing holes filled and take the ford badge off and get those holes filled, so the only emblems on my car are teh 2 GTs on the side

It will leave a hole in your trunk! :) ...I had to get mines filled! ;)

you should just buy a color matched ford emblem. thats what i did. and get rid of the gt emblem if you dont get the cobra filled.
http://www.mustangtuningforums.com/a...tachmentid=179

not the GT, the ford yes

Sounds good until you race them and they find out it aint no supercharged....lol

Really, exactly what is this gunna do for the look of your car?....Theres a point when you start going to far with lil crap like this.

How big is the hole that is left when you remove the side badges? I was playing around with the idea of wiring up some side markers in place of my GT badges.

I removed my 40th fender padges and the GT badge on the back and went with 281 badges. i get a lot of compliments on them, kinda an oldschool kickback.

They were 3/8". Perfect for some wires but not big enough for to much else.

I put the 281 badges on to, they look sweet.

i got a wild hair up my a$$ today. so i decided to take off my gt badges. i thaught they were just stick on. no they left a hole. some retard that painted it clear coated over the badges. so i have to find some double sided adhesive to put them back on. any good ideas for the adhesive? i didnt want any badges on it, but now there is an out line where the clear coat is comming off. i need a fix fast ( but good ) its hiddeous.

yeah you couldve asked, the side badges have a hole...the only one that doesnt have a hole is the rear GT badge

On the 96-98 the rear Ford emblem has holes.