mgw
 

ok just recieved my new still in the box except the instructions shifter, and after reading was wondering just how many of you have em and installed em yourself? and if installed yourself what about these so called stops....read it say to just leave em out. any help would be great thanx, mike

It's an easy install, make sure you read all of the instructions, it tells you how to install the shift stops correctly.

I love my MGW.

you have the 3650 trans...it has built in stops...so you dont need to use the stops that came with your kit.

Short throw is a simple install. It should take about an hour to complete and most of that time is removing and putting back on the noise isolator because its 4 fine threaded long bolts that seem to get tight in the back with minimal room to work.

first time it is a bit tricky....cause u dont wanna break anything..but the shifter bezel is a biotch to get out...dont worry about breaking anything...itll take a lot...

when u put the bolts back in...make sure they go in correctly and dont strip them...i did that and i have to retap them when i take my shifter out to swap to the mgw

ive done it 3 times to my friends stangs...1st time (my car) tooke me about 1 hr....2nd time took about 45....3rd time took about 15 mins

thanks guys now i just need to find a good shifter knob and i will be set

Yea, if you have a t3650 then you dont have to use the stops. Install is easy, just take your time.

Get this shfit knob, http://i9.ebayimg.com/03/i/06/19/4d/2e_1.JPG

haha
yea homiez!!!

MGW makes a great shift knob.

i have the mgw composit knob and its nice. expensive though.

UPR then went and made one very similar... but cheaper!
(and the top of it looks cheaper too... MT sells them, 15 dollar difference)

what you guys think about these?
http://mrt-direct.com/shiftball/shiftballs.php

those are pretty sick i like the gloss black with the pony and 5 speed..