how do I set my valves after rebuild?
I tourqed my rockers when they were off of the block to 18 ft. pounds and now that I have done a couple of heat cycles, I have a few that seem to be clattering away. How should I correctly tighten them from here?
|
stock rockers, bolt down rollers?
|
If they are stock rocker arms then tighten to 25 foot pounds
|
Also needs to be done while rotating the crank to make sure you are on the closed side of the cam
|
All times are GMT -7. The time now is 05:26 PM. |
© 2024 MH Sub I, LLC dba Internet Brands