Mustang Forums - View Single Post - Anyone intrested in 5.4L swaps, in here. Need you to opine.

skylark · 05-09-2008, 08:53 PM

Nightgwing, That intake will not match up to 3V heads will it? Aren't 2V, 3V and 4V heads all different as far as ports go? Or are they making an HPS for 3V's also?
I was going to say how about an SVO intake, the granddaddy of the Bullitt, dual 57mm throtle as you have now but a HUGE lower plenum that makes the Bullitt look.... well small! Had to make it smaller for the street and mass production as the SVO is for higher rpm's OR LARGER MOTORS! I did the coolant mod to it and could email a pic to somebody if they could post it here. I would like to have it in my sig but with webTV I can't do much.
If I go ahead with the 5.4 it would likely make an excellent intake for the motor if it fits with hiod clearance. I was told that the adapter plates raise the intake an inch or two, correct? How much, PM Me, Mark

05-09-2008, 08:53 PM	#4213 (permalink)
skylark Senior Member Join Date: May 2008 Posts: 102	Nightgwing, That intake will not match up to 3V heads will it? Aren't 2V, 3V and 4V heads all different as far as ports go? Or are they making an HPS for 3V's also? I was going to say how about an SVO intake, the granddaddy of the Bullitt, dual 57mm throtle as you have now but a HUGE lower plenum that makes the Bullitt look.... well small! Had to make it smaller for the street and mass production as the SVO is for higher rpm's OR LARGER MOTORS! I did the coolant mod to it and could email a pic to somebody if they could post it here. I would like to have it in my sig but with webTV I can't do much. If I go ahead with the 5.4 it would likely make an excellent intake for the motor if it fits with hiod clearance. I was told that the adapter plates raise the intake an inch or two, correct? How much, PM Me, Mark Last edited by skylark : 05-09-2008 at 08:58 PM.